Usystems EDGE-3 - Network; Device Manager

Page 37
WebUI - Seng
Network Sengs TAB
The default network sengs are as follows:
Device name: EMSXXXXXX
DHCP: Set to ‘O’
IP address: 192.168.0.10
Netmask: 255.255.252.0
Gateway: 0.0.0.0
To change these sengs select the text elds and adjust accordingly and then click Save Sengs. If the IP address is changed
reconnect using the new IP address aer the EMS has been restarted. Do this by selecng restart from the power icon buon on
the top right of the screen, allow up to 3 minutes for it to power on fully with the new IP address. Type the new IP address into the
browser.
NTP Server IP: To change to a dierent NTP Server enter it’s IP Address and use the Save Sengs buon, a restart of the EMS is
required to apply these sengs.
MAC address: Displays device's MAC (Media Access Control) address. This cannot be changed.
Serial number: Displays the serial number assigned to the EMS
To change the date and me for your country select the drop down menu and select your me zone and restart the EMSfor the
seng to change.
SMTP Sengs
This must be set to allow emails alerts/alarms to be sent.
Server address (IP/Domain): Add the IP or Domain of your email server
Username: Add the email address which will the alarms from
Password: Add the password of the email address
Make sure that the default admin email address is changed to the administrator who is going to be receiving emails to change
passwords of users that request a forgoen password.
To make sure that the seng used are correct select the ‘Save Sengs’ buon.
Use ‘Send Test Email’ to test if the sengs are correct and working with the EMS. A email address must be entered to send the
test email too.
To use the Send Test Email and alarms select the ‘Add new email’. Select the alarms for each email address entered.
Device manager
This tab details all devices that are aached to the EMS. When adding new devices to the EMS cross check in device manager that
they are displaying correctly.
Hardware Version - This displays the hardware version of the EMS. This may be required for support.
Soware Version - This displays the soware version of the EMS. This may be required for support.