Usystems EDGE-3 - Safety Instructions

EDGE-3 Soundproof MDC O&M
Page 6
Introducon
Safety Instrucons
• The EDGE system is to be powered from a dedicated power source (Refer to Model Idencaon & Rang plate for voltage
input).
• The EDGE system is not to be powered via an extension cord.
• The EDGE System Fans are factory installed and congured for either 100-130V or 200-240V (Refer to EDGE Rang plate and
EMS marking for the voltage set to).
• The EMS appliance outlets are for the EDGE fan power only. DO NOT plug any other appliance into the EMS power Outlets.
• When performing maintenance, the EDGE System should be Isolated or the appropriate instrucons followed.
• When Installing equipment within the EDGE ensure addional safety Instrucons are specied.
• Power and distribuon cables should be installed and routed so that they are unlikely to be damaged in normal operaon.
• Cable ingress to the equipment should only be made via the dedicated cable entry points.