Usystems EDGE-3 - User Accounts

EDGE-3 Soundproof MDC O&M
Page 38
Device manager
Hardware version: Displays device’s hardware version
Soware version: Displays the device’s soware version
Default Units: Change between Metric to Imperial
Servo: If 1 or 2 servos are connected to the EMS this must be selected to ‘ON’ for the EMS to control the servos
Universal U1 - U4 Input Type: Select the sensor type that is added to these ports on the EMS
IO 1 - 6 Sensor Type: Select which digital sensor is plugged into the EMS
Camera: Enable to acve.
Camera 1: Select the camera from the drop-down menu, if unable to nd any make sure that the USB cable from the camera is
plugged into any of the USB ports.
Camera 2: Select the camera from the drop-down menu, if unable to nd any make sure that the USB cable from the camera is
plugged into any of the USB ports.
UTelligent Locking Address: Add the IP address of the UTelligent locking system into the text boxes and selecng the save icon
when complete. This will then display on the dashboard.
User Accounts
On rst login to the device it will have a default login (‘Admin’) and password (‘Admin12$’) it is recommend to change the Admin
login password.
To add a new user select the Add User buon at the boom of the table then ll the elds with the required informaon. .
There are 5 levels of access -
R (Read-only user) can only access DASHBOARD TAB
RC (Read-only + camera user) can only access DASHBOARD + Camera TAB
W (Write user) access to all TABs other than Camera and EMS sengs TAB
WC (Write and Camera user) can access almost all TABs other than EMS Sengs TAB
S (Super-user) can access all TABs
Once completed select ‘Save Sengs’.
Passwords must be a minimum of 8 characters with at least 1 number and 1 upper case leer.
If the account is not required there are two opons depending on the situaon. If the user is no longer needed for the foreseeable
future the account can be removed by selecng the bin icon in the users row. The other opon is to deacvate the account in the
event that it needs to be suspended, this is achieved by selecng the ck icon on the users row. To reacvate it, select the cross
icon. These opons can only be performed by the admin account or super user.
Change the email address of the account by eding the text eld under email and select save icon when nished, this is the same
for the Access level. Enter the user rights by the corresponding leers list in on informaon panel and selecng save once
completed, a conrmaon pop up will appear if correct. If incorrect entries have been entered a dierent pop up will appear
showing error inputs.