2GM
1-7-2
• When replacing DIMM
Firmware upgrading requires the following tools:
DIMM (P/N 2GM01210/302GM01210)
Procedure
1. Turn the power switch off and disconnect the
power plug.
2. Remove the pin and then remove the
memory cover.
3. Remove the DIMM from the DIMM slot on the
main PWB.
4. Insert the new DIMM into the DIMM slot on
the main PWB.
* Insert the DIMM securely all the way into the
slot. If the power switch is turned on when
the DIMM is not properly inserted, the main
PWB may be damaged.
5. Refit the memory cover.
6. Insert the power plug and turn the power
switch on.
DIMM slot
DIMM
Figure 1-7-3
To Next Page
Loading...
Need help?
General
