2GM
1-4-13
Maintenance
Description
item No.
U203 Operating DP separately
Description
Simulates the original conveying operation separately in the DP.
Purpose
To check the DP.
Method
1. Press the enter key. A selection item appears.
2. Select the item to using the up/down cursor keys.
Display Operation
DP With paper
DP (Non P) Without paper (continuous operation)
3. Press the start key. The operation starts.
* When operation with paper is selected, if no original is set in the DP, this mode cannot be run. When
operation without paper is selected, if originals are set in the DP, this mode cannot be run.
4. To stop continuous operation, press the stop/clear key.
Completion
Press the back key when the operation stops. The indication for selecting a maintenance item No. appears.
U207 Checking the operation panel keys
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the enter key.
2. 01 appears and the leftmost LED on the operation panel lights.
3. As the keys on the operation panel are pressed in order from the left to right, the figure shown increases in
increments of 1. If there is an LED corresponding to the key pressed, the LED will light.
4. When all keys are pressed, all LEDs will light for 10 s.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
U260 Changing the copy count timing
Description
Changes the copy count timing for the total counter and other counters.
Purpose
To be set according to user (copy service provider) request.
If a paper jam occurs frequently in the eject section when the number of copies is counted at the time of paper
ejection, copies are provided without copy counts. The copy service provider cannot charge for such copying.
To prevent this, the copy timing should be made earlier.
If a paper jam occurs frequently in the paper conveying or fusing sections when the number of copies is
counted before the paper reaches those sections, copying is charged without a copy being made. To prevent
this, the copy timing should be made later.
Method
Press the enter key. A selection item appears.
Setting
1. Select the copy count timing using the up/down cursor keys.
Display Description
Feed When secondary paper feed starts
Eject When the paper is ejected
2. Press the enter key. The setting is set.
Completion
Press the back key. The indication for selecting a maintenance item No. appears.
To Next Page
Loading...
Need help?
General
