FAX Operation (Basic)
3-19
3
38 Use the or key to select [TX Start Speed] or
[ECM] and change settings as necessary, and then
press the OK key.
39 Use the or key to check if each item was
entered correctly.
40 Press the OK key.
41 Press the OK key again.
42 Use the or key to check if the destination was
set correctly.
43 Press the OK key. The destination is added to the
Address Book.
Group Registration
You can register several destinations that have been registered to be contacted as a unit. This method is
convenient because several destinations can be designated at one time. Up to 50 groups can be registered.
NOTE: Group registration requires destinations that have been registered as contact registration. Perform the
necessary contact registration in advance.
1 Press the System Menu/Counter key.
2 Press the or key to select [Edit Destination].
3 Press the OK key.
FAX Detail:
C
b
TX Start Speed: 3/ 4
33600bps
[ Change ]
Key Description
TX Start Speed To change the transmission start speed, press
this key. Select the speed from 33,600 bps,
14,400 bps, and 9,600 bps.
ECM ECM (error correction mode) is a function to
automatically resend an image that has not
been correctly sent or received due to the
effects of noise on the telephone line during
transmission. To change the ECM
communication setting, press this key.
To Next Page
Loading...
Need help?
General
