V2 CITY2+L - Page 47

ENGLISH
- 45 -
PARAMETER VALUE DESCRIPTION DEFAULT MEMO
i.Adi
Enabling the ADI device
Thismenumakesitpossibletoenableoperationofthedeviceconnected
to the ADI connector.
PLEASE NOTE:selectingSi andpressingMENUaccessesthe
congurationmenuforthedeviceconnectedtotheADIconnector.
Thismenuismanagedbythedeviceitselfandisdifferentforeachdevice.
Pleaserefertothemanualforthedevice.
IftheSi optionisselected,butnodeviceisconnected,thedisplaywill
showaseriesofdottedlines.
ExitingtheADIdevicecongurationmenureturnstothei.Adi option
no
no
Interfacedisabled
Si
Interfaceenabled
ASM
Anti-skid
Whenanopeningorclosingoperationisinterruptedbyacommandor
fortheinterventionofthephotocell,theset-uptimefortheopposite
movement would be excessive, so the control unit operates the motors
onlyforthetimenecessarytorecovertheactuallycoveredjourney.
Thiscouldbenotsufcient,particularlyinthecaseofveryheavygates,
asbecauseoftheinertiaattheinversionmomentthegaterunsanextra
space in the previous direction that the control unit is not able to take
intoaccount.Ifafteraninversionthegatedoesnotreturnexactlytothe
startingposition,itispossibletosetananti-skidtimethatisaddedtothe
timecalculatedbythecontrolunitinordertorecovertheinertia.
no
no
Function disabled
0.5” - 3.0”
Anti-skid time
FinE
End of Programming
Thismenuallowstonishtheprogramming(bothdefaultand
personalized)savingthemodieddataintomemory
no
no
Itdoesnotexitfromtheprogrammenu
Si
Itexitsfromtheprogrammenubystoringthesetupparameters