Vacon 100 X - Option Boards

8
vacon • 105 Options
8.4 Option boards
VACON
®
100 X drive family embodies a wide selection of expander boards with which the available
I/O of VACON
®
100 X frequency converter can be increased and its versatility improved.
There are two board slots (labelled D and E) on the VACON
®
100 X control board. To locate the slot,
see chapter 5. Usually, when the AC drive is delivered from the factory, the control unit doesn’t in-
clude any option board in the board slots.
The following option boards are supported:
See the Option boards User’s Manual to use and install the option boards.
Code Description Note
OPTB1
Option board with six bidirec-
tional terminals.
With jumper blocks it’s possible to
use each terminal as digital input or
as digital output.
OPTB2
I/O expander board with a
thermistor input and two relay
outputs.
OPTB4
I/O expander board with one
galvanically isolated analogue
input and two
galvanically isolated analogue
outputs (standard signals
0(4)…20mA).
OPTB5
I/O expander board with three
relay outputs
OPTB9
I/O expander board with five
42…240 VAC digital inputs and
one relay output.
OPTBF
I/O expander board with ana-
logue output, digital output and
relay output.
On the OPTBF board, there is one
jumper block for selecting the ana-
logue output mode (mA/V).
OPTBH
Temperature measurement
board with three individual
channels.
Supported sensors: PT100, PT1000,
NI1000, KTY84-130, KTY84-150,
KTY84-131
OPTC4 Lonworks option board
Pluggable connector with screw ter-
minals
OPTE3 Profibus DP option board
Pluggable connector with screw ter-
minals
OPTE5 Profibus DP option board 9-pin Sub-D terminal
OPTE6 CANopen option board
OPTE7 DeviceNet option board
Table 35. Option boards supported in VACON
®
100 X.