Vacon 100 X Installation And Maintenance Manual

Receipt of delivery vacon • 16
Service support: find your nearest Vacon service center at www.vacon.com
2
2.2 Unpacking and lifting the AC drive
The weights of the AC drives vary according to frame size. You may need to use a piece of special
lifting equipment to move the converter from its package. Note the weights of each individual frame
size in Table 3 below.
Table 3. Frame weights.
VACON
®
100 X drives have undergone scrupulous tests and quality checks at the factory before they
are delivered to the customer. However, after unpacking the product, check that no signs of trans-
port damage are to be found on the product and that the delivery is complete.
Should the drive have been damaged during shipping, please contact the cargo insurance company
or the carrier in the first instance.
2.3 Accessories
After having opened the transport package and lifted the drive out, check immediately that these
various accessories were included in the delivery. The contents of the accessories bag differ by
drive size:
2.3.1 Frame MM4
Frame
Weight
[kg] [lb]
MM4 8.8 19.4
MM5 14.9 32.8
MM6 31.5 69.4
Item Quantity Purpose
STO terminal connector 1
Six pin black connector (see
Figure 9) to use STO function
M4 x 12 DIN6900-3-Combi-Delta-Tx
screw
10 Screws for control cable clamps
M1-3 Cable clamp 5 Clamping control cables
M4 x 12 DIN6900-3-Combi-Delta-Tx
screw
6 Screws for power cable clamps
M25 Cable clamp 3 Clamping power cables
‘Product modified’ sticker 1 Information about modifications
HMI cap
*
*. Provided only if the drive is delivered with the keypad.
1 Closing cap for the HMI connector
Table 4. Content of accessory bag, MM4.

Vacon 100 X Specifications

General

Brand	Vacon
Model	100 X
Category	Controller
Language	English