Vacon 100 X - 4 Power Cabling

Power cabling vacon • 28
Service support: find your nearest Vacon service center at www.vacon.com
4
4. POWER CABLING
The mains cables are connected to terminals L1, L2 and L3 and the motor cables to terminals
marked with U, V and W. See principal connection diagram in Figure 17. See also Table 11 for the
cable recommendations for different EMC levels.
Figure 17. Principal connection diagram.
Use cables with heat resistance in accordance with the application requirements. The cables and
the fuses must be dimensioned according to the AC drive nominal OUTPUT current which you can
find on the rating plate.
Keypad
Control
U/T1
V/T2
W/T3
M
L1
L2
L3
Power unit