Vacon 100 X - Page 86

8
vacon • 83 Options
Figure 61. Typical editing of values on graphical keypad (text value).
Figure 62. Typical editing of values on graphical keypad (numerical value).
Parameters with checkbox selection
Some parameters allow selecting several values. Make a checkbox selection at each value you wish
to activate as instructed below.
Figure 63. Applying the checkbox value selection on graphical keypad

Start/St op Setup
Rem Control Place
I/O Control
KeypadStopB utton
Yes
Start Funct ion
Ramping
STOP READY I/O
ID:172 M3.2.1

Edit
Help
Add to favo rites
Rem Cont rol Place
STOP READY I/O
ID: M3.2.1

Rem Cont rol Place
STOP READY I/O
M3 . 2. 1
I/O Con trol
Fieldbu sCTRL

Start/St op Setup
Rem Control Place
I/O Control
KeypadStopB utton
Yes
Start Funct ion
Ramping
STOP READY I/O
ID:172 M3.2.1

Rem Cont rol Place
STOP READY I/O
M3.2.1
I/O Con trol
Fieldbu sCTRL
OR:
OK
OK
OK
BACK
RESET
9257.emf
OK
9256.emf
...
OK
Symbol for checkbox selection