Introduction vacon • 7
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
1
1.4.2 Sections and options
Sections and options are selected using the line-up configuration tool.
The available sections and options are introduced in Chapter 2.
1.4.2.1
System layout and footprint drawing
System layout and footprint drawings are created based on the sections and options selected with
the line-up configuration tool.
The documentation supplied with the project delivery is introduced in Chapter 6.
Table 4. Example of selected sections and options from the configuration tool
# Section type Section category Options
1ADS_600 Control +PES
2 MIS_2500 Incoming power +ICB
3AFS_13 Incoming power -
4 IUS_4 Outgoing power +ODU
5IUS_10 Outgoing power +ODU
6IUS_10 Outgoing power +ODU
7 IUS_12 Outgoing power +ISC, +ODU
8 IUS_7 Outgoing power +ODU
9 IUS_12 Outgoing power +ISC, +ODU
To Next Page
Loading...
Need help?
General
