Vaisala Indigo200 - Page 49

Display message Description Recommended action
Unable to measure all
parameters
Some of the measurements you
have configured to be
displayed are currently not
available. This can be caused,
for example, by the probe
heating feature: parameters
that are aected by heating
cannot be shown while the
heating cycle is ongoing.
Analog output [output]
calibration in progress
The analog output (1—3)
identified in the message is
being calibrated. See Analog
output adjustment (page 43).
Analog output [output] test
active
Test output is being sent from
the analog output (1—3)
identified in the message. See
Analog output adjustment
(page 43).
Chapter 8 – Maintenance and troubleshooting
49