Starting up transmitter using touchscreen
display
1. Remove the plastic protection cover on the touchscreen display.
2. Power up the transmitter.
Powering up takes some minutes.
After the power-up, the Measurements view opens, showing the 2 preferred
measurement parameters from each connected probe.
3. Select the configuration menu symbol at the upper right corner of the touchscreen.
4. The default language of the user interface is English. If you want to use another language,
select it in Transmitter > Language.
Your transmitter is now ready for operation. You can next go through these additional settings:
• Date and time
20 M212290EN-D
To Next Page
Loading...
