3. To set date and time automatically:
a. In Set date and time, select Automatically.
b. Select Time zone.
c. In NTP server addresses, configure the Network Time Protocol (NTP) servers that the
transmitter will attempt to synchronize with.
NTP synchronization requires that the transmitter has a network
connection and the IP address of the NTP server is reachable.
d. Select Date format and Time format.
4. To set date and time manually:
a. In Set date and time, select Manually.
b. Select Time zone.
c. In Date and time, select Day, Month, Year, and Time. Then select Set.
d. Select Date format and Time format.
The new date and time appear at the lower right corner of the touchscreen.
23
ENGLISH
To Next Page
Loading...
