Vaisala WXT536 - Aligning; Figure 25 Grounding with Bushing and Grounding Kit

Chapter 4 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 49
Use the Bushing and Grounding Kit to run a cable from the fixing screw
to a grounding point. The kit includes:
- A longer fixing screw
- Two nuts and washers
- Abiko connector for the grounding cable
The kit does not include the grounding cable. The minimum grounding
conductor size is 4 mm
2
(AWG 11). Use a 16 mm
2
conductor to achieve
a good ground connection.
Figure 25 on page 49 shows how to assemble and install the kit.
Figure 25 Grounding with Bushing and Grounding Kit
Aligning
To help the alignment, there is an arrow and the text "North" on the
bottom of the transmitter. Align the transmitter so that this arrow points
north.
1=Nut
2 = Fixing screw
3 = Abiko connector between two washers
WXT536 WXT535 WXT534 WXT533 WXT532 WXT531
X XX