Chapter 7 ___________________________________________________ Retrieving Data Messages
VAISALA_______________________________________________________________________ 83
CHAPTER 7
RETRIEVING DATA MESSAGES
This chapter presents the general and data message commands.
Each communication protocol has its own section for data message
commands.
For details on changing the message parameters, units, and other
settings, see Chapter 8 Sensor and Data Message Settings, on page 127.
NOTE
Type commands in CAPITAL letters.
NOTE
The parameter order in messages is as follows:
Wind (M1): Dn Dm Dx Sn Sm Sx
PTU (M2): Ta Tp Ua Pa
Rain (M3): Rc Rd Ri Hc Hd Hi Rp Hp
Supv (M5): Th Vh Vs Vr Id
Comp (M): Wind PTU Rain Supv (parameters in above order)
The order of the parameters is fixed, but you can exclude any
parameter from the list when configuring the transmitter.
To Next Page
Loading...
