Chapter 7 ___________________________________________________ Retrieving Data Messages
VAISALA_______________________________________________________________________ 87
Measurement Reset (aXZM)
This command interrupts all ongoing measurements except rain
measurement and restarts them.
Command format in ASCII and NMEA 0183: aXZM<cr><lf>
Command format in SDI-12: aXZM!
Example (ASCII):
0XZM<cr><lf>
0TX,Measurement reset<cr><lf>
Example (SDI-12):
0XZM!0 (= device address)
Example (NMEA 0183):
0XZM<cr><lf>
$WITXT,01,01,09,Measurement reset*50<cr><lf>
where
a = Device address
XZM = Measurement break command
<cr><lf> = Command terminator in ASCII and NMEA 0183
! = Command terminator in SDI-12
To Next Page
Loading...
