VAMP 150 - Configuring Communication Protocols COM

VAMP Ltd
Motor protection relay
Operation and Configuration
VAMP 150
VM150.EN005 Vamp 24h support phone : +358 (0)20 753 3264
23
5.8. Configuring communication protocols
COM
Via the submenus of the COM menu the following functions
can be read and set:
Active
• Communication protocol of REMOTE port (Protocol)
• Message counter (Msg#)
• Communication error counter (ERRORS)
• Communication time-out counter (Tout)
Profibus
• Profibus profile (Mode)
• Transfer rate of converter
• Profibus Tx Buf lentgh (InBuf)
• Profibus Rx Buf lentgh (OutBuf)
ModBus
• Device slave number at ModBus Slave Protocol
• Target slave number at ModBus Master protocol (Addr)
• ModBus transfer rate (bit/s)
• ModBus parity check (Parity)
SpaBus
• Slave number (Addr) when relay connected to SPA
substation
• SPA-Bus transfer rate (bit/s)
• Event mode (Emode)
IEC-103
• Slave address (Addr)
• Transfer rate (bit/s)
• Interval for sending measurements (MeasInt)
• ASDU6 response time mode (SyncResMod)
TCP/IP (ModBus TCP, only in VAMPSET)
• IP address of the relay (IPAddr)
• Subnet mask (NetMsk)
• IP address of the Name Server
• IP address of the SNTP Server (NTPSvr)
Local Port
• Transfer rate of local serial bus (bit/s)