VAMP Ltd Arc protection system
User manual
VAMP 220 / 220R
VM220.EN004 Vamp 24h support phone : +358 (0)40 573 6316
23
5. System installation
WARNING!
Read through the handling instructions of this manual
carefully before undertaking any mounting or wiring work.
5.1. Safety notes
National electrical safety regulations must be obeyed when
work is carried out under live conditions. The unit
manufacturer takes no responsibility for accidents caused by
incorrect working or protection practice.
The correct handling of the unit under all mounting and
operating conditions forms the foundation for a safe use of the
product.
WARNING!
All separately marked notes and warnings must be observed.
The wiring work must be performed according to national
standards and possible requirements set by the customer.
CAUTION!
Do not connect the auxiliary supply voltage as long as installa-
tion work is going on.
5.2. Preparing for installation
Before installing the system, make sure that the environmental
requirements are fulfilled. See the environmental conditions
specified in the TECHNICAL DATA chapter.
CAUTION!
The product contains components, which are liable to damage
by electrostatic discharge (ESD). The unit must not be opened,
unless necessary protective measures against ESD have been
taken.
WARNING!
Operational safety cannot be guaranteed in environments that
do not fulfill the specified environmental conditions.
To Next Page
Loading...
Need help?
General
