Need help?Do you have a question about the VAMP 220 and is the answer not in the manual?
General| Frequency | 50/60 Hz |
|---|---|
| Current Inputs | 3 |
| Protection Functions | Overcurrent, Voltage, Frequency |
| Mounting | DIN Rail |
| Standards | IEC 60255 |
Provides essential safety notes and warnings to be observed during installation work.
Provides an overview of the required wirings for the master unit, including CTs, trip circuits, and auxiliary supply.
Instructs on connecting the master unit to protective earth via the PE terminal.
Details how to connect the auxiliary supply voltage to the master unit's input terminals.
Details how to connect the master unit and slave units using the VX 010 modular cable.
Outlines methods for checking wirings, including visual inspection and measuring.
Guides users on navigating and operating the master unit's control panel.
Describes how the system reports and logs arc fault tripping alarms.
Explains how tripping alarms are obtained via output contacts and indicated on the master unit control panel.
Details how to access stored arc fault data, including sensor addresses and BI/O line identifiers.
Explains the warning code 200 displayed when phase currents exceed the start value.
Explains how the ERROR indicator and fault messages signal internal faults in the master unit.
To Next Page
