Description of the Service Mode
Calibration
Calibration: Description
Fig. 2 Calibration of all the thermocouples by
comparison of the temperatures measured with
the theoretical boiling temperatures.
Youwillndadetaileddescriptionofthis
function in the chapter Heating > Calibration.
The process is automated and must not be
interrupted.
Attention! The unit's installation altitude
must be correctly set before you calibrate it! If
you do not know or are unsure of this, please
do not calibrate the unit! This has already
been done at the factory!
v03 • July-2016 • Hen
Service Mode Module
IV.17
2
Line Units Serial number (starting from) Sw Revision
VCCM
VCCWE
All ExxXH1009xxxxxxx 01-00-08
To Next Page
Loading...