Installation, Operating & Maintenance Instructions
Series 650 DN 100-250 (I.D. 4“ - 10”), CC-Link
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
280672EB
2010-12-15
25/94
Description Required tool
12. Install the CC-Link wires, see also
«Connector type» table below
Note:
If cable at pos. A (first or last station) install
«TR» between 1 and 2
1 x blue to 1
1 x white to 2
1 x yellow to 3
If cables at pos. A + B (…stations…) install
2 x blue to 1
2 x white to 2
2x yellow to 3
Screw driver
size 1
13. Close the cover of connector and fasten the
screws a little
Pozidriv screw driver
size 2
14. Connect the connector and fasten it with the
screws at controller (sample picture)
Allen Wrench
2.5 mm
15. Push the cover down to controller and
fasten the cover screws (sample picture)
Pozidriv screw driver
size 2
To Next Page
Loading...
