Installation, Operating & Maintenance Instructions
Series 650 DN 100-250 (I.D. 4“ - 10”), CC-Link
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
280672EB
2010-12-15
24/94
Description Required tool
9. Remove the wire coat carefully about 5mm
Wire strippers
10. Insert the cable(s) at connector hosing as
shown in the pictures, see also chapter CC-
Link connector
Note:
If valve in CC-Link network is at «first or last
station» install the CC-Link cable at position
A and close B with blind plug C.
If valve in CC-Link network at
«…stations…» install the CC-Link cables at
position A and B.
11. Fasten the strain-relief screw until the cable
can not pulled out by manual force
Screw driver
size 4
5mm
Shield
Pos. A
Pos. B
C
To Next Page
Loading...
