Vatech A9

Table of Contents
iii vatech A9 (Model: PHT-30CSS) Installation Manual
Table of Contents
Notice i
Important Notes ii
Table of Contents iii
1. Introduction 1
1.1 Manufacturer's Liability ................................................................................... 1
1.2 Customer’s Responsibility ............................................................................. 1
1.3 Conventions in this Manual ............................................................................ 2
1.4 Marks and Symbols ......................................................................................... 7
1.5 Standards and Regulations ............................................................................ 9
2. Choosing an Installation Site 9
2.1 Room Requirements ....................................................................................... 11
2.2 Specifications for Electrical Installation ...................................................... 15
2.3 Electrical Requirement .................................................................................. 15
2.4 Environmental Specifications ...................................................................... 17
2.5 Exposure Switch Installation Options ......................................................... 18
2.6 Installation Versions ...................................................................................... 20
2.7 Installing the Warning Lamp and Door Interlock Switch ........................... 24
2.8 Installing the Emergency Stop Switch ......................................................... 24
3. Before Installing the System 25
3.1 Required Tools ............................................................................................... 25
3.2 Checking the ShockWatch and TiltWatch ................................................... 27
3.3 Unpacking Boxes ........................................................................................... 28
3.4 Checking the Parts ........................................................................................ 34
4. Installing the Equipment: Base Stand (Optional) 41
4.1 Assembling the Base and Main Units .......................................................... 41
4.2 Installing the CEPH Unit (Optional) .............................................................. 46
4.3 Installing the Wall and Column Brackets .................................................... 49
4.4 Fixing the Base (Optional) ............................................................................ 55
4.5 Connecting the Cables to the Equipment. .................................................. 59