Vega VEGAPULS 6X - Mounting preparations, mounting strap

18
5 Mounting
VEGAPULS 6X • Two-wire 4 … 20 mA/HART
66190-EN-221107
The housing cover is unlocked in the opposite way.
Note:
The locking screw has two holes drilled through the head. Thus it can
also be sealed.
5.3 Mounting preparations, mounting strap
The mounting bracket is supplied loose as an optional accessory for
the plastic horn antenna. It must be screwed onto the sensor with the
three M5 x 10 hexagon socket screws and spring washers before
setup:
•
Required tool: Hexagon spanner size 4
•
Max. torque: see chapter " Technical data"
Therearetwodierentvariantsofscrewingthestraptothesensor,
see following illustration:
1 2
Fig. 9: Mounting strap for screwing to the sensor
1 Variant 1: Inclination adjustable in steps
2 Variant 1: Inclination steplessly adjustable
Depending on the selected variant, the sensor can be rotated in the
strap:
•
Single chamber housing
– Inclination in three steps 0°, 90° and 180°
– Inclination 180° steplessly
•
Double chamber housing
– Inclination in two steps 0° and 90°
– Inclination 90° steplessly