Vega VEGAPULS 6X - Special parameters

99
12 Menu overview
VEGAPULS 6X • Two-wire 4 … 20 mA/HART
66190-EN-221107
Menu item Parameter Selection/Display Default setting
Sensor information Device name, order code, serial num-
ber, hardware/software version, Device
Revision, factory calibration date, device
address, Loop current mode, Fieldbus Pro-
leRev.,ExpandedDeviceType,sensor
acc. to SIL, sensor acc. to WHG, Bustype ID
-
Sensor character-
istics
Congurationfea-
tures
Simulation Measured value Percent,linearizedpercent,llingheight,
distance, scaled, measurement reliabili-
ty, electronics temperature, measuring rate,
operating voltage, current output
Percent
Measured value
memory (DTM)
Device memory Echo curve of the
setup
Save echo curve of setup
-
Echo curve memory Echo curve memory
Measured value
memory
Measured value memory
Event memory Event memory
Function test Start proof test, start device test
12.3 Special parameters
Parameter Designation Presentation Default setting
SP1, SP2 Activate measuring range
start limiting
Manual limiting of measuring
range start
100 %
Deactivated
0.000 m
SP3 Safety on the vessel bottom
or measuring range end
0 %
+ ...m
1.000 m
SP4 Correction of the propaga-
tion speed
∆v
0.0 %
SP5, SP6 Factor for noise averaging
rising
Factor for noise averaging
falling
ø
...
2
2
SP7 Deactivatelterfunction"
Smooth raw value curve"
active
Deactivated