Vega VEGAPULS 6X - Set up with PC;notebook; Preparations (Bluetooth); Connecting (Bluetooth)

86
11 Set up with PC/notebook
VEGAPULS 6X • Two-wire 4 … 20 mA/HART
66190-EN-221107
11 Set up with PC/notebook
11.1 Preparations (Bluetooth)
Make sure that your PC/notebook meets the following system require-
ments:
•
Operating system Windows 10
•
DTM Collection 10/2020 or newer
•
Bluetooth 4.0 LE or newer
Make sure that the Bluetooth function of the display and adjustment
module is activated. For this, the switch on the bottom side must be
set to " On".
Factory setting is " On".
1
On
O
Fig. 59: Activate Bluetooth
1 Switch
On = Bluetooth active
O= Bluetoothnotactive
Activate the Bluetooth connection via the project assistant.
Note:
Older systems do not always have an integrated Bluetooth LE. In
these cases, a Bluetooth USB adapter is required. Activate the
Bluetooth USB adapter using the Project Wizard.
After activating the integrated Bluetooth or the Bluetooth USB adapt-
er, devices with Bluetooth are found and created in the project tree.
11.2 Connecting (Bluetooth)
Select the requested device for the online parameter adjustment in
the project tree.
Whenestablishingtheconnectionforthersttime,theoperatingtool
andthedevicemustauthenticateeachother.Aftertherstcorrect
authentication, each subsequent connection is made without a new
authentication query.
System requirements
Activate Bluetooth con-
nection
Connecting
Authenticate