Vega VEGAPULS 6X - Wiring plan, single chamber housing

47
6 Connecting to power supply
VEGAPULS 6X • Two-wire 4 … 20 mA/HART
66190-EN-221107
1 2
Fig. 46: Connection steps 5 and 6
1 Single chamber housing
2 Double chamber housing
6. Insert the wire ends into the terminals according to the wiring plan
Note:
Fixedconductorsandexibleconductorswithferrulescanbe
inserteddirectlyintotheterminalopenings.Inthecaseofexible
conductors for opening the terminals, use a screwdriver (3 mm blade
width) to push the actuator lever away from the terminal opening.
When released, the terminals are closed again.
7. Check the hold of the wires in the terminals by lightly pulling on
them
8. Connect the shielding to the internal ground terminal, connect the
external ground terminal to potential equalisation
9. Tighten the compression nut of the cable entry gland. The seal
ring must completely encircle the cable
10. Reinsert the display and adjustment module, if one was installed
11. Screw the housing lid back on
Theelectricalconnectionisnished.
6.3 Wiring plan, single chamber housing
The following illustration applies to the non-Ex as well as to the Ex-ia
version.