Vega VEGAPULS 6X - Mounting versions, plastic horn antenna

19
5 Mounting
VEGAPULS 6X • Two-wire 4 … 20 mA/HART
66190-EN-221107
Fig. 10: Adjustment of the inclination when mounted horizontally on the wall
Fig. 11: Rotate when mounted vertically on the ceiling
5.4 Mounting versions, plastic horn antenna
The optional mounting strap allows simple mounting of the instrument
on a wall, ceiling or boom. Especially in the case of open vessels, this
isasimpleandeectivewaytoalignthesensortothesurfaceofthe
bulk solid material.
The following versions are available:
•
Length 300 mm
•
Length 170 mm
Note:
For safe operation of the device, stable, permanent mounting on a
load-bearing surface (concrete, wood, steel, etc.) is required. Take
this into account when choosing the installation location and use suit-
able fastening materials (screws, dowels, pipe clamps, etc.).
The instrument is normally mounted vertically with a bracket on the
ceiling.
This allows swivelling the sensor up to 180° for optimal orientation
and rotating for optimal connection.
Mounting strap
Mounting strap - Ceiling
mounting