Vega VEGAPULS 6X - Page 98

98
12 Menu overview
VEGAPULS 6X • Two-wire 4 … 20 mA/HART
66190-EN-221107
Diagnostics
Menu item Parameter Selection/Display Default setting
Status Diagnosis status Diagnosis status -
Status parameter ad-
justment
Changecounter,modicationdate,check-
sum (CRC) current, date checksum current,
checksum (CRC) last SIL locking, date last
SIL locking
-
Measured value
status
Percent,linearizedpercent,llingheight,
distance, scaled, measurement reliability
-
Status outputs Current output -
HART Device Status Fielddevicemalfunction,Conguration
changed, Cold start, More status available,
Analogoutputxed,Analogoutputsaturat-
ed, Non-primary variable of limits, Primary
variable of limits
-
Status additional
measured values
Electronics temperature, measuring rate,
operating voltage
-
Echo curve Echo curve Indication of echo
curve
Peak indicator Distance Current value, min. distance, max. distance
Actual value
Measurement reli-
ability
Current value, min. measurement reliability,
max. measurement reliability
Measuring rate Current value, min. meas. rate, max. meas.
rate
Electronics temper-
ature
Current value, min. eletronics temperature,
max. electronics temperature
Operating voltage Current value, min. voltage supply, max.
voltage supply
Measured values Measured values Percent,linearizedpercent,llingheight,
distance, scaled, measurement reliability
Additional measured
values
Electronics temperature, measuring rate,
operating voltage
Outputs Current output, Primary Value (PV), Sec-
ondary Value (SV), Tertiary Value (TV),
Quarternary Value (QV)
Diagnostic behaviour Echo loss Behaviour in case of echo loss, time until
fault signal
Output fault current
Electronics temper-
ature - Behaviour
outsidethespeci-
cation
Outsidethespecication,outputfaultcur-
rent
Status signals Activation of: Function control, Outside the
specication,Maintenancerequired
Function check, out-
sidespecication,
maintenance re-
quired