A payment card with an embedded EMV chip
must be inserted in the chip card reader. The
card must be inserted in the chip card reader with
the chip facing up and towards the PINpad.
A payment card with a magnetic strip must be
swiped through the magnetic card reader. The
card must be swiped through the magnetic card
reader with the magnetic strip facing down and
towards the PINpad.
3.8 Replacing a printer roll
Complete the following steps to replace a printer roll. Always be careful during this procedure! The
cutting edge is sharp and the printer may be hot.
1. Press the release button and open the
printer cover. Remove the old printer roll if
necessary.
2. Insert the new printer roll as indicated in the
above photograph. Make sure to leave a
strip of paper sticking out and close the
printer cover. Tear off the strip of paper
along the cutting edge.
To Next Page
Loading...
Need help?
General
