VeriFone e355 User Manual

COMMUNICATION INTERFACES
Wi-Fi
36 E355/E265 USER AND BEST PRACTICES GUIDE
Personal Area
Network (PAN)
Profile
The BT_MGR application is used to configure this profile. This profile is used to
connect to a smart device in tethered mode to access the internet. When
connected in PAN Mode, BT_MGR provides Bluetooth link maintenance and
reconnection logic.
By default PAN profile is not available from the BT_MGR user interface. This
feature can be enabled via a configuration variable. For more information, refer to
Verix eVo Bluetooth Manager Users Guide, VPN - DOC00327.
Bluetooth Manager (BT_MGR) Role and OS Interaction
This is documented in detail in Verix eVo Bluetooth Manager Users Guide, VPN -
DOC00327 for more information.
Bluetooth Pairing
This is documented in detail in Verix eVo Bluetooth Manager Users Guide, VPN -
DOC00327 for more information.
Pairing Behavior
Apple iOS devices don't always pop up the numeric comparison window for
pairing if the device was previously connected even after you "Forget Device." If
you "Forget Device," turn off Bluetooth, reset device, turn on Bluetooth, it will then,
most-of-the-time, pop up numeric comparison window. If you don't mind that you
can just press OK on the connecting device and it will still pair. Recent iOS
updates have improved this behavior.
Wi-Fi
Wi-Fi interface is available on e355 device. Mobile PINpad architecture is not
available over Wi-Fi interface. This interface is primarily used for VHQ
communications. In the standalone mode it can be used as a general purpose
communication interface.
Per PCI4 requirements, open and WEP encryption modes are not permitted. The
available encryption modes are:
• WPA2-Personal
• WPA(2)-Enterprise (EAP-TLS, EAP-FAST, EAP-PEAP)
The device supports both 2.4GHz and 5 GHz bands. It can be set to use only one
of these bands or both the bands ("auto") from NCP. This setting is available
under Wi-Fi device driver setup.
Low power Wi-Fi modes are supported in e355. This mode is configurable from
NCP. Power Mode 2 is default and recommended. An application usually does not
directly work with the Wi-Fi driver. It is used by the Communication Engine library
packaged with EOS.
NOTE
Smart Device PAN mode (tethering) is usually only supported on smart devices
that have a 3G/4G radio installed.

VeriFone e355 Specifications

General

Brand	VeriFone
Model	e355
Category	Payment Terminal
Language	English