4.5 Placing the Unit on a Floorstand
WARNING! Risk of unit falling over. Improper installation of floorstand can cause equipment damage, injury,
or death. Read all instructions before attempting to install floorstand.
CAUTION: Risk of contact with sharp edges, splinters, and exposed fasteners. Can cause injury. Wear
appropriate OSHA approved personal protective equipment (PPE) when attempting to move, lift, remove
packaging from, or prepare for installation.
CAUTION: Risk of heavy unit falling into defective raised floor. Can cause injury and equipment damage. Prior
to installation, all floor tiles immediately around floorstand are to be removed and inspected. Make sure tiles
are not cracked, and ribs have not been cut. If free from defects, re-install. Replace with new tiles if defects
are found.
NOTICE
Upon arrival verify that labeled equipment matches Bill of Lading. Carefully inspect all items for either visible or
concealed damage.
Damage should be immediately reported to carrier and a damage claim filed with a copy sent to Vertiv or to your
sales representative.
NOTE: Unit to be placed onto lower module using process that will provide safest method based on site layout.
Professional installers to be used when placing unit.
4.5.1 Packaging Material
All material used to package this unit is recyclable. Please save for future use or dispose of the material appropriately.
Figure 4.7 Vertiv™ CoolPhase CDU Floorstand and Hardware
32 Proprietary and Confidential ©2024 Vertiv Group Corp.
4 Equipment Inspection and
Handling
Vertiv™ CoolPhase CDU Installer/User Guide
To Next Page
Loading...
