Vertiv RPC2 - Events Tab

-or-
Click the checkbox at the top of the table to select all the receptacles in the table.
2. Click the Disable Receptacle Power icon, then click OK on the pop-up window to confirm to disable power for
the selected receptacle.
-or-
Click Cancel to return to the Device Explorer window without disabling the power for a receptacle.
3. From the pop-up window, click OK to acknowledge that the process completed successfully.
To cycle power for a receptacle:
1. From the Device Explorer window, click the checkbox in the row of the appropriate receptacle.
-or-
Click the checkbox at the top of the table to select all the receptacles in the table.
2. Click the Cycle Receptacle Power icon, then click OK on the pop-up window to confirm to cycle power for the
selected receptacle.
-or-
Click Cancel to return to the Device Explorer window without cycling the power for a receptacle.
3. From the pop-up window, click OK to acknowledge that the process completed successfully.
To lock a receptacle:
1. From the Device Explorer window, click the checkbox in the row of the appropriate receptacle.
-or-
Click the checkbox at the top of the table to select all the receptacles in the table.
2. Click the Lock Receptacle icon, then click OK on the pop-up window to confirm to lock a selected receptacle.
-or-
Click Cancel to return to the Device Explorer window without locking a receptacle.
3. From the pop-up window, click OK to acknowledge that the process completed successfully.
To unlock a receptacle:
1. From the Device Explorer window, click the checkbox in the row of the appropriate receptacle.
-or-
Click the checkbox at the top of the table to select all the receptacles in the table.
2. Click the Unlock Receptacle icon, then click OK on the pop-up window to confirm to unlock a selected
receptacle.
-or-
Click Cancel to return to the Device Explorer window without unlocking a receptacle.
3. From the pop-up window, click OK to acknowledge the process completed successfully.
To cause a receptacle's LED to blink:
1. From the Device Explorer window, click the checkbox in the row of the appropriate receptacle.
-or-
Click the checkbox at the top of the table to select all the receptacles in the table.
Vertiv | RPC2™ Communications Module Installer/User Guide | 19