5. Click the Save icon.
To assign receptacles to a user group:
1. From the System tab’s navigation tree, click Authorization - Groups.
2. Check the box next to either the user group or a custom group where the receptacles are added.
NOTE: Receptacles cannot be assigned to the administrator, poweruser or system user groups. Each of these default
groups has its access level set in the software.
3. Check the boxes next to the receptacles to be added to the group.
-or-
To assign all receptacles, click the box at the top of the column.
4. Click the Save icon.
Users
From the User Names window, an administrator can add or delete users and change user passwords.
NOTE: The administrator’s user password cannot be changed on this window.
To add a user:
1. From the System tab’s navigation tree, click Authorization - Users.
2. Click the Create Local User icon.
3. Enter the username and password and confirm the password.
4. Click the Save icon.
To delete a user:
1. From the System tab’s navigation tree, click Authorization - Users.
2. Check the box next to the user to be deleted.
3. Click the Delete Local User icon.
4. Click OK when prompted.
To change a user password:
1. From the System tab’s navigation tree, click Authorization - Users.
2. Check the box next to the user whose password needs to be changed.
3. Click the Change Local User's Password icon.
-or-
To change your own password, from the side navigation bar of the System tab, click Authorization - Change
Password.
4. Enter and confirm the new password.
5. Click Save icon.
Vertiv | RPC2™ Communications Module Installer/User Guide | 34
To Next Page
Loading...
