37
Date separator to change the separator used
to display the date. Highlight your new date
separator then press
Select.
Automatic update of date and time
This is a network service. You can set your Vertu
phone to update the date and time from the
network when you turn the phone on. If the clock in
your phone is 30 seconds or more off the network
time, the phone will be updated automatically to
reflect the network time.
Automatic update of the date and time does not
change the time you have set for the alarm clock,
calendar, or alarm notes. These are in local time.
Updating may cause some alarms that you have set
to expire.
To use automatic date and time update:
> From the stand-by display, press Menu.
> Scroll to the Settings menu then press Select.
> Scroll to Time and date and press Select.
> Scroll to Auto-update of date & time, the
current setting is shown, press
Select.
> Scroll to one of the following options then press
Select:
On to update the time automatically.
Confirm first to request confirmation before
updating the time. You can accept or decline the
update.
Off to disable automatic updates of time and
date.
PERSONAL SHORTCUTS
Shortcut Menu
You can customise the shortcut list for easy
access to your favourite functions. You can modify
the items in the list and change the order in which
they as accessed.
To modify the shortcut menu list:
> From the stand-by display, press Menu.
> Scroll to the Settings menu then press Select.
> Scroll to Pers. shortcuts and press Select.
> Shortcut options is highlighted, press Select.
> Scroll to one of the following options then press
Select to customise the shortcut list:
Select options to change the entries available
in the shortcut list. Check the box next to each
entry you want in the list then press
Done.
Confirm your changes when prompted.
Organise to change the order of the entries in
the shortcut list. Highlight the entry you want to
move then press
Move. Select the move option
then press
Select. When you are finished
modifying your list, press
Done. Confirm your
changes when prompted.
Voice commands
Some of your Vertu phone’s key functions can be
voice-activated. This can be particularly practical
when using the headset as it avoids you needing to
access the phone.
To add a voice command:
> From the stand-by display, press Menu.
> Scroll to the Settings menu then press Select.
> Scroll to Pers. shortcuts and press Select.
> Scroll to Voice commands and press Select.
> Select the desired command folder, scroll to the
command for which you want to add a voice tag,
then press
Options.
> Add command is highlighted, press Select.
> Press Start and speak after the tone. You cannot
activate or add a voice command during a call or
while sending or receiving data over a GPRS
connection.
To use a voice command:
> From the stand-by display, press and hold Go to
until
Speak now is displayed. If using the
headset, press and hold the
ANSWER/ END button.
> Say your command which should be automatically
recognized and performed.
CONNECTIVITY
You can also define the settings for (E)GPRS data
connections. You can then connect the phone to a
compatible PC using the data cable and use the
phone as a modem to enable GPRS connectivity
from the PC.
GPRS
Your Vertu phone can use general packet radio
service (GPRS) for high-speed data connections.
With GPRS, you can stay connected to the mobile
Internet and allow faster downloads without
completing a dial-up connection. GPRS connectivity
can be used to enhance MMS messaging, Web
browsing sessions, e-mail, and the PC dial-up.
GPRS is typically billed as an “always-on” function
and you are only charged for the data you transfer.
Enhanced GPRS (EGPRS), also known as EDGE
(enhanced data rates for GSM evolution) is similar
to GPRS but the connection is much faster.
To Next Page
Loading...
