8 9
REV. 2.1 22-06-2020REV. 2.1 22-06-2020
3. LIFTING AND TRANSPORT
2. CONDITIONS FOR USE
All operations that comply with the following conditions are considered “normal”:
• the user applies all instructions in this manual and CE directives
• all safety standards are respected, not removing the casing or safety catches installed by
the manufacturer
•
• the unit has to be connected under an automatic cut-out switch of 30mA
• the unit is connected to an earthing system in order to prevent disturbances or electric
shocks
• the unit is connected to an electric circuit with separate NEUTRAL and EARTH wires
• the unit is not used at high temperatures (over 40ºC) or low temperatures (below 10ºC)
•
•
solenoid valves and the cylinders
• the machine is not used in the presence of explosive gases, dust or oil fumes
•
the pressurized circuit
• the unit is connected to a compressed air system with minimum constant internal pressure
of 5.5 bar
• the unit is installed in a factory not over 1000 mt from sea level
•
•
maintenance work
The manufacturer declines all responsibility for damage caused to people or things by the
machine if:
•
•
• the power supply is not constant or does not correspond to requirements
• the machine is not earthed, or there are electronic problems in the electrical system
• the motor has not been subjected to the scheduled maintenance operations
•
• the user demonstrates total or partial failure to observe the instructions
• rain or snow get in contact with the unit
It is absolutely prohibited to:
• remove the casing and safety devices from their positions, thereby posing a risk to the user
• remove the eye protection mirror without equipping the user with special eye protection
glasses in compliance with the law
• deactivate the safety catches installed by the manufacturer, thereby posing a risk to the user
• make changes to the machine without authorization from the manufacturer, thereby posing
a risk to the user
• exceptional circumstances
2.1- Guarantee conditions
All unit components have a 1 (ONE) year guarantee and should be send to the manufacturer
for inspection if found to be defective.
All pieces damaged due to negligence of the end user and/or incorrect adjustments to the
not be covered by the guarantee. These will be charged at the normal price, including
consequent delivery and/or installation costs.
with straps or balts that will insure the stability
during the transport.
Make sure that during lifting the whole
machine rests on the forklift forks.
Make sure that during unloading the whole
machine rests on the forklift forks. Place it on
remove the top part of the packing box by
pulling it upwards.
To Next Page
Loading...
