VICI DBS PG Plus Rack 100 - Most Common Options; Part Numbers; Remote Connections (I;O Board); Cascading

11
PG PLUS RACK + ZERO AIR
& GC PLUS RACK USER MANUAL
www.vicidbs.com
Version 2.00.0000
5.1. MOST COMMON OPTIONS
5.1.1. Pa r t Nu mber s
OPTION PART NUMBER
BOARDS/INTERFACES
I/O Board DB-10155
Remote Control RS232 (software + cable) DB-PH200-107
Remote Control USB (software + cable) DB-PH200-108
CASCADING OPTION
Cascading Hardware Kit DB-CASC-001
On/Off and Non-Return Valve DB-CASC-002
Buffer Reservoir 0.75 Liters DB-CASC-003
Cable for Cascading, Requires I/O Board DB-10157
PR with Pressure Gauge DB-CASC-004
Cascading Hardware Kit - High Purity DB-CASC-005
Pressure Regulator with Pressure Gauge - High Purity DB-CASC-006
AUTO-REFILL OPTION
Rell Valve - Replacing Inlet Pump (for H
2
O pressurized lines) DB-RH200-020
5.1.2. Remote Connections (I/O Board)
The hydrogen generators are tted with an optional remote-control feature, which allows the user to remotely
check the status of the generator and to start/stop the production of hydrogen. The contacts used in the
remote control are potentially free relay contacts. The contacts can be congured via software as normally
open or normally closed (see the Conguration section). The maximum voltage and current ratings for the
contacts are 1A / 48V. The pin conguration of the remote connector is shown in the table below.
Remote Connector Pin Conguration:
PIN DESCRIPTION
1+2 Start (12-30 VDC polarity independent)
3+4 Standby
5+6 Reaching external pressure
9+10 Low water level
11+12 Bad water
13+14 Change water