6
PG PLUS RACK + ZERO AIR
& GC PLUS RACK USER MANUAL
www.vicidbs.com
Version 2.00.0000
2.3. ENVIRONMENTAL CONDITIONS
OPERATING TEMPERATURE Minimum +15º C, Maximum +40º C
HUMIDITY < 80% RH, non-condensing
ATMOSPHERIC PRESSURE From 850 to 1150 hPa
EXTERNAL VIBRATIONS < 0.05g/25Hz
INSTRUMENTS POSITION Horizontal
3. SAFETY
3.1. NOTES OF FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in an installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the distance between the equipment and the receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
3.2. CORRECT USE
The hydrogen generator is designed to produce hydrogen for laboratory use. The unit should only be used
for this purpose, according to the specications and instructions provided in this manual. In particular, the
following warnings must always be observed:
• Indoor use only
• Never operate the unit at temperatures below 0°C (32°F). This will cause irreversible damage to the
electrolysis cell.
• Use only pure, deionized water (see “Filling the Water Tank”)
• Operate the unit in a room with sufcient ventilation (see “Placing the unit”)
• Always unplug the unit from the mains power supply before accessing the internal components for service
or repair work
To Next Page
Loading...
