Vicon CMP 3001F - After Work; Detachment of the Mower; Moving the Mower into Transport Position

G0202MKD3 EN16
4AFTER WORK
4.1 Moving the mower into transport
position
After termination of the work the mower must be lifted up in
front of the tractor in order to allow transportation on public
roads.
Attention:
Ensure the machine has completely stopped any ro-
tation prior to commencing the folding up procedure!
1
Pressurize lifting cylinder (42) through control lever.
Now the cylinder will lift the mower.
2
Fully lift the mower by using the 3-pt front linkage. Now
the mower will be in transport position.
4.2 Detachment of the mower
Attention:
Do never detach unless the machine is in working po-
sition!
1
Move mower into mowing position (see 3.2).
2
Lift the mower with the 3-pt-front hitch.
3
Pull spring clip out of pin (35), remove pin (35) from
lower supports.
4
Pull out the jack stand (3) horizontally. Turn the jack
stand 90° to the right.
5
Put the jack stand in the support.
6
Slide the pin (35) through the hole of the upper sup-
ports (2), then safety by the spring clip.
7
Place the blocking pins (43) in their holder.
8
Lower the mower by the 3-pt-hitch till the jack stand (3)
rests on the ground. If necessary move the valve control
lever into floating position: the mowing unit will lower
fully to the ground.
9
Detach machine from tractor.
42
43
MD0209
MD0206
3
2
35
4
36
B
37
0
o