Cleaning
49
Cleaning
Use the correct cleaning agents
Use only PH neutral cleaning agents when cleaning the machine.
PH neutral cleaning agents give your machine maximum protection.
Cleaning agents with either high or low PH value can be corrosive on
plastic, rubber and varnished surfaces.
• High pressure cleaning equipment may be used to clean.
However, the area around the bearings should be cleaned using
gentle squirts of water.
• Hydraulic components should only be cleaned with gentle squirts
of water to protect the gaskets.
After cleaning
After cleaning the machine, carry out the following:
Let the remaining water run off for about 1 hour.
Remove the collected water behind all guards.
Check that the machine's guards are closed.
Connect the tractor's PTO and let it run at a moderate speed.
Disconnect the tractor's PTO.
• When the machine has stopped rotating, carry out the following:
lubricate the machine according to the lubrication program
»Maintenance intervals« page 56
If necessary, protect all polished parts with suitable protective oil.
To Next Page
Loading...
