Maintenance
57
Safety in connection with maintenance work on the machine
When working on the machine the tractor must be stopped and
secured.
This prevents the PTO shaft from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected following the
instructions serious accidents causing damage to limbs can occur.
When working on the machine:
• The tractor engine must be stopped.
• The ignition key must be removed.
• The PTO shaft must be disconnected.
• The hand brake must be activated.
Always use original spare parts on the machine
Always use original spare parts.
Original spare parts should be used for safety reasons.
The manufacture warranty becomes void if non-original spare parts
are being used.
Make sure that all protective guards are in place
Check that all protective guards are in place.
This ensures that the machine will offer maximum protection to the
operator.
If the safety guards are removed or not used it may result in serious
injuries and accidents.
PTO shaft check
Refer to the manufacturer's service and maintenance instructions
delivered with the PTO shaft.
To Next Page
Loading...
