Maintenance
66
Turn the cutting discs by hand until the damaged knife is in the
position shown.
Inspect the bolts and knives for wear.
Inspect the bolt for damage or wear.
• If the bolts are damaged or worn, they must be changed.
The minimum diameter of the bolt must not be less than 16 mm
(
5
/
8
”).
»Knives« page 90
»Synopsis« page 20
Use a suitable wrench to tighten the bolt to the torque shown.
If the machine is fitted with knife quick release*, the same requirement
applies for bolt wear.
»Knives« page 90
Pull and release the lock.
Close the front guard.
Minimum
16 mm (
5
/
8
”)
95 Nm +/- 5
70 ft/lb. +/- 3
Min. 16 mm (
5
/
8
”)
Spring
Knife
To Next Page
Loading...
