26
EN
16657715_en 05/2006
To check and correct the length, proceed as
follows:
hitch the round baler to the tractor,
drawbar must be set as described in Section 4.3,
pull apart the universal drive shaft and mount the
halves to the tractor and machine,
hold the universal drive shaft halves under each
other,
when taking all curves and when driving straight,
ensure that:
- a minimum overlap of b = 200 mm is
guaranteed,
- the universal drive shaft is not sitting on the
block, minimum distance a = 20 mm,
- there is sufficient clearance between the
drawbar and the universal drive shaft.
if it is necessary to shorten the length, saw the same
amount off both the sliding and protective tubes.
carefully burr the pipe ends, remove shavings and
grease sliding points well.
4.5 Adjusting the bale density
The density of the round bales depends on the crop
conditions and the preselected baling pressure.
The following adjustments can be made:
1. Tailgate sensor
2. Hydraulic pressure acting on the tailgate
cylinders
To Next Page
