43
EN
16657715_en 05/2006
5.5 Binding
5.5.1 General
Both a net wrapping and twine binding system are
available for the round baler. The baler can be fitted
with either one or both binding processes. If necessary,
the crop can be wrapped using both binding processes
one after the other. It is also possible to retrofit either
system.
Only use good quality net to reach best wrapping results.
The outer diameter of the roll should not exceed 320
mm and its width should not be inferior to 1230 mm.
Maximum core length should be 1300 mm.
Machines with standard equipment can be fitted with
net and twine spools as shown in the table alongside.
The standard version allows for the variant net and
twine reel configurations shown alongside.
Recommended net roll manufacturers:
RKW AG
Rheinische Kunststoffwerke
Rossbacher Weg 5
D-64720 Michelstadt
www.rkw-ag.com
Twine quality:
- Plastic twine with a running length of 400 to
700 m/kg
- Sisal twine with a running length of 200 to
330 m/kg
5.5.2 Twine binding
If the round baler is fitted with a twin-threaded twine binding mechanism, the crop can be bound into
bales which are stable in shape with a preselected number of crosswise twine bindings.
Twine tying can be activated automatically or manually via the control box. The number of twine wraps
(18/22/26) is set on the machine box (see chapter 5.1.3).
The twine container is located in front of the tying mechanism and holds 6 twine reels (125) / 4 twine
(121). An accessory container to hold 5 extra twine reels can be mounted on the machine for exclusive
twine tying. The net reel container can also be used to hold 6 twine reels when the machine is used for
both twine and net tying.
To Next Page
Loading...
