Page 89
MNVADCJ01_1729_EN
6.11.6 Patrol
The three patrol sequences are set during OSM setup.
(1÷3): selects the active patrol sequence and starts immediately, without pressing the
key. Warning!
If the patrol function is active the dome will not respond to other commands until it has been
stopped by
(1÷3): selects the active patrol sequence and waits for the key to be pressed to activate
the selected sequence
: starts the active patrol sequence. Warning! If the patrol function is active the dome will not respond to
other comma
nds until it has been stopped by
: stops the patrol.
6.11.7 Other commands and special codes
horizontal rotation through 180 degrees (autoflip)
Enabling a
utomatic autoflip:
enable; disable
Information on video:
information on the camera, service information,
no information shown on video
“Area title”:
shown, hidden
“Event display mode”:
enabled, disabled
: autofocus on
To Next Page
Loading...