Videotec DCJ - Page 223

Page 93
MNVADCJ01_1729_EN
To enable the various functions press the keys required by the on-screen menu. The following table shows the
functions available in the menu with the corresponding keys on the DCJ:
The numeric keys enable the various items in the on-screen menu.
Joystick
: selecting the menu items
If it is necessary to use telemetry (move the dome) while inside the on-screen menu, use the joystick and at the
same time keep the

 corresponds to the <SEQ> control on the on-screen menu.
 corresponds to the <1
st
> contorl on the on-screen menu. In many cases it will switch to the inital display in
the menu.
 corresponds to the <ALARM> control on the on-screen menu.
 corresponds to the <SET> control on the on-screen menu.
 corresponds to the <CLR> control on the on-screen menu.
 end of setup.
If necessary, see the dome handbook for further details.
6.13.4 Using the dome
Joystick:
:positioning the dome.

: zoom in and zoom out.


and : iris close and iris open.
 and : focus near and focus far.
 : autofocus.
 : activates the “Stabilize" function.
 : passage from “day” mode to “night” mode, and vice versa.
6.13.5 Autopan
: start autopan.
Moving the joystick will pass to manual operation of the dome.
See the dome handbook for further details.
6.13.6 Preset, scan
(1÷63): store the current position as preset position number XX.
(1÷63): movement towards preset position XX.