ViewSonic PG707W - Page 44

44
i. These buons funcon the same as the ones on the OSD menus or remote
control.
ii. To switch between input signals, click on your desired signal.
NOTE:
• The source list varies according to the connecons available on the projector.
• When you use the projector control panel or remote control to change the OSD
menu sengs, it may take a while for the web browser to synchronize these
changes with the projector.
2. The Tools page allows you to manage the projector, congure the LAN control
sengs and secure access to remote network operaons on this projector.
i ii iv
iii
v
vi
i. This secon is only used with the Crestron Control System. Please contact
Creston or refer to its user manual for setup informaon.
ii. You can name the projector, keep track of its locaon and the person in
charge of it.
iii. You can adjust the LAN Control Settings.
iv. Once set, access to the remote network operaon on this projector will be
password-protected.
v. Once set, access to the tools page will be password-protected.
NOTE:
• To prevent errors, only input the English alphabet and digits on the Tools page.
• Aer making the adjustments, press the “Send” buon and the data will be saved
for the projector.
vi. Press “Exit” to go back to the Remote Network Operaon page.