Document: LT0732 QE20 Fibre Networking User Manual
Issue 1.0 24 May 2023 Page 8-1
8. Module Replacement
Part Numbers for Ordering
FP2024 FP,QE20 FIBRE NETWORK KIT, SINGLE MODE
FP2025 FP,QE20 FIBRE NETWORK KIT, MULTI MODE
The complete Fibre Networking kit with either single mode or multi-mode fibre
switch.
FP2029 FP,QE20 GP MOUNTING BRACKET, 1 MODULE WIDE
Bracket for mounting PIB, ATA & VIF, or other modules
PA0644 PCB ASSY VIF0907 VOIP INTERFACE BOARD (DIN)
Includes 1 x LM0448 and 2 x LM0552, and DIN rail mounting hardware.
SU0321 SUNDRY CISCO VOIP ADAPTER (ATA 192)
SU0319 SUNDRY MOXA 5 PORT E/NET SW (2 MULTI MODE FIBRE)
SU0320 SUNDRY MOXA 5 PORT E/NET SW (2 SINGLE MODE FIBRE)
SU0325 SUNDRY MOXA 5 PORT E/NET SW
SU0326 SUNDRY MOXA 8 PORT E/NET SW
FP0986 FP PIB PANEL-LINK IP BRIDGE
LM0138 LOOM DB9M-DB9F ALL PINS STRAIGHT THRU 1.8M
Suitable for Re-Flashing VIF module firmware or connecting to its diagnostic
port.
LM0448 LOOM, QE20 VoIP ADAPTER POWER
LM0552 LOOM RJ11 TO RJ11 1.5M ALL PINS STRAIGHT THROUGH
Re-Configuration
8.1.1 Configuring a Replacement VIF
The VIF does not require any configuration, apart from setting its address on the DIP
switches and the two links the same as on the module being replaced.
Don’t use an old VIF in QE20, as the firmware version may not be compatible. At
least firmware V1.06 is needed.
8.1.2 Configuring a Replacement ATA
QE20 is designed to use the ATA 192. Do not replace the ATA 192 with an earlier or
other manufacturer’s model. The firmware in the ATA 192 must be at least version
11-2-3.
The replacement ATA must be configured as documented in each site’s
documentation pack.
Refer to Section 3.8 for configuring the ATA and the ATA Administration Guide for
further information on the settings.
To Next Page
Loading...
